Use the data wheel to enter a ◊.ULTRADRIVE PRO DCX2496 User Manual On this SETUP page you can activate the GLOBAL LOCK function (ON), 2. The unit will prompt you to enter a password. To lock a parameter page you must activate the PAGE LOCK function (ON).

Be sure that at the new link to be activated and the name of the inputs that will be overwritten least two outputs are open (UNMUTE OUTPUTS TO ALIGN), otherwise no delay (black field).ULTRADRIVE PRO DCX2496 User Manual Press OK or CANCEL to subsequently copy further pages in the same way. MONO (no stereo links) Configuration OUT Stereo Link not available activated by enabling SHORT Delay 1 ➟ 2 ➟ 3 ➟ 4 ➟ 5 ➟ 6 “OUT STEREO-LINK”.ULTRADRIVE PRO DCX2496 User Manual When this function is On, the display provides a warning note that shows both In the AUTO-ALIGN sub-menu you can mute or open all outputs. The PARAM button selects individual parameters from one page, the data wheel edits them.ULTRADRIVE PRO DCX2496 User Manual The following link options (output configurations) are available: MONO 123456 LINK-Activation 1. Are there any affordable options these days, or is it still a $300 plus cost? Probably clipping like mad from a too strong signal.I had been reading in the past about putting a volume control in between the DCX and the amplifier, which would have the added benefit of giving me more control over the volume. It just results in very distorted and quiet output. Now both analog and digital outputs work without the DCX crashingHowever, when using the digital in, the output doesn't work with the receive inputs on my old amplifier (or any of the input ports for that matter). I pulled it apart and reseated all of the ribbon cables, and the DIP chip on the main board. I'd rather use the digital out for better quality, if possible.Any ideas?Thanks. It looks like the output is too strong, as it clips very heavily for a few seconds, then goes into the flashing lights state.Analog output run through my old Yamaha A520 integrated amplifier's send/receive ports (which aren't true preout/main ins supposedly) works fine although volume control is a bit awkward.

Dcx 2496 firmware v1.18